NC-300 servo high-speed aluminum cutting machine is an explosive machine among Jincheng Machinery's fully automatic aluminum cutting machines. This machine has been deeply loved by customers in the machining industry. Today I will share with you its general process requirements.

　　1. Requirements for the quality of the pipe-straight, with a diameter tolerance of ±0.10, multiple pieces can be cut, otherwise it must be cut by a single piece;

　　2. The front and rear seat pressure plates are easy to wear, and must be frequently polished to eliminate pits, and the sharp edge chamfer R0.5 arc, otherwise it will be easy to clamp, the length is out of tolerance, and the pipe is scratched;

　　3. Air source pressure; after the pipe wall is below 0.4mm, the pressure is 0.4-0.5Map, when the pipe wall thickness is above 0.5mm, it will increase to 0.5-0.6Map, if the pipe wall is above 0.8mm, more than 3 pieces/cut, pressure 0.6-0.7Mpa, try to work under 0.8Map pressure;

　　4. The blade thickness is appropriate, and the best thickness is 0.8-1.2mm.

　　5. The thinner the pipe, the lower the pressure source, the more cutting quantity, the less deformation of the pipe.