In the process of using high-speed circular sawing machine, you will encounter various problems, some of which are common in daily life. Learning to deal with it by yourself will make enterprises using high-speed circular sawing machines more efficient and save unnecessary time and cost.

　　The following are some basic common sense problems and solutions:

　　Common problem 1. The high-speed circular saw machine has large vibrations from time to time

　　solution:

　　First check whether the equipment is placed high or low or uneven, check whether the equipment bearing is damaged, the machine casing should be kept intact, whether the grinding wheel of the equipment is eccentric, etc., and finally check whether the gear is intact and whether the bearing seat is worn; if If there is still no way to solve the problem, contact the manufacturer immediately for processing.

　　Problem 2: The circular saw blade suddenly stops working or the equipment stops moving:

　　solution:

　　This situation is mostly a circuit problem. You should immediately cut off the power supply, check the circuit, test whether the voltage is stable, whether the power supply is normal, whether the ground wire is connected, whether there are any nearby equipment that affects the voltage, etc. There is another situation, which is If there is a problem with the equipment itself, see whether the saw blade is stuck or other parts should be checked together; if there is a problem with the equipment itself, this needs to be checked by professionals.

　　Question 3: The operator's voice is very loud when operating the equipment

　　solution:

　　Most of the possibilities are bearings, such as eccentricity, damage to the grinding wheel, damage to the gear, etc., such hardware damage should contact the supplier for repair or replacement.

　　Problem four, metal circular sawing machine equipment produces smoke

　　solution:

　　This kind of phenomenon generally means that the equipment is entering the aging stage, which is inevitable, but if it is not long before the equipment is bought, it is likely to be caused by long-term failure to maintain and maintain the equipment. If the company does not care about the cleaning and hygiene of the equipment, There is no reasonable rest time for excessive use as required; there is also a situation where the equipment parts are aging, or the metal circular saw blade has reached the end of its service life and needs to be replaced. When such a situation occurs, the equipment should be stopped immediately. Check the fault carefully, and turn it on again after the problem is solved.

　　Problem 5, peculiar smell of machine tool equipment

　　solution:

　　If the operator finds that the equipment has a peculiar smell while working, he should immediately stop the equipment and cut off the power supply. It may be due to line problems, system inspections of the equipment, or the equipment is exhausted and the odor is caused by high temperature phenomena; if not If you can find out the situation, you should ask a professional to come over and overhaul it.

　　Problem six, the protective shell on the high-speed circular saw machine is worn out

　　solution:

　　The company should carefully check the integrity of the equipment when purchasing equipment. If the protective shell is found to be damaged or worn during use, it may be caused by human negligence, such as: the staff accidentally pressed the equipment and used it for time If it is too long, the temperature is too high during use, it will melt, and it will wear through for too long, you can contact the manufacturer for replacement.