Introduction to this article:

　　Strictly speaking, the aluminum cutting machine is a consumable product. During use, if it is properly used and maintained, it will greatly improve the sawing efficiency, save materials and materials, and can avoid various problems, especially for Cleaning up the waste generated after sawing is particularly important!

　　Core focus:

　　1. Excessive sawdust will seriously affect the use effect of the saw blade, such as shortening its service life, jamming, jumping teeth, and abnormal sounds.

　　2. Failure to clean up the sawing aluminum chips in time will result in reduced accuracy of the sawing workpiece and the tailings cannot be processed. Seriously affect the stability of the overall equipment during sawing.

　　3. Taking preventive measures in time can effectively avoid the discovery of various problems. Correct maintenance and maintenance must be formulated, and the aluminum chips must be cleaned up regularly every day.

　　Detailed description of the hazards and prevention of sawdust

　　Hazard 1: Affect the set number of revolutions and produce jumping teeth or abnormal noise;

　　During the sawing process of the aluminum cutting machine equipment, if aluminum chips stick to the saw blade, the saw blade will not reach the normally set rotation value. If the blade continues to feed, it will be prone to jumping teeth, resulting in abnormal sawing sound.

　　Treatment plan: Before sawing, check whether the wire brush used is installed correctly. If waste particles enter the saw blade during sawing, the equipment should be stopped for cleaning in time.

　　Hazard 2: The hazard of waste accumulation in the jaws of the clamp;

　　The clamping device is composed of a vertical clamp and a horizontal clamp. The clamp shaft generates an alarm. Check whether there is waste accumulation in the clamp jaws. The accumulation of aluminum chips in the jaws will make it impossible to return to the zero position, and the motor load will increase, which will affect the accuracy. The tailings cannot be processed, and the affected materials cannot be sawed.

　　Treatment plan: Before moving the equipment, check whether there is any waste between the parts of the aluminum cutting machine equipment. Before each start-up operation, the aluminum cutting machine should be carefully inspected once.

　　Finally, Jincheng Machinery reminds again: When using the aluminum cutting machine, you must clean up the iron filings in time. For example, use the blower to clean the iron filings of the equipment. It is best to keep it 2-3 times a day, and do a good job in the handover of each shift. Check, the scraps must be cleaned up, open the saw blade cover to blow off the aluminum scraps on it, and check the saw blade scrap cleaning brush. If it is damaged, it must be replaced in time.

　　Maintaining good maintenance can not only improve the efficiency of the equipment, but also avoid the emergence of various problems for the equipment, shorten the production time of the enterprise and extend the service life of the equipment.